MAGSY GmbH

This tank-type flow magnetic separator serves to the separation of metal impurities from dry powder materials of food, chemical or raw-material processing industries; during unloading, the material is transported from the tank using pressurized air.

The separator consists of two fully removable parts: magnetic component and separator body. Remove the component with magnetic pipes from the magnetic separator body and, using handrail, pull the magnets to the upper position. This way stainless steel pipes become demagnetized so metal parts fall off.

 Magnetic separators are ended by parallel threads with a possibility of equipping them with transitional components adapting them to other dimensions. Magnetic separator can be connected to the pipeline DN 80. However, we are able to adapt the separator to various input and output dimensions, as well as types of ending.

These are intended for separation from easily permeable mixtures with worse pouring properties and higher grain size, which would not fall down continuously through the above described magnetic grids. In their standard modification, they are fitted with ferritic magnets and if required, we can deliver them also in a modification fitted with rare-earth (NdFeB) magnets.                                                                  The adjustable spreading roof is a great advantage of this type; the roof may be used to to route material directly towards the magnetic boards, achieving thus effective magnetic separation as much as possible even if installation is performed under a certain angle.

We produce the plate magnetic separators with the incoming hole diameter of 100, 150, 200 ,250 and 300 mm.

We keep on trying to improve our products and make them even better than ever before. In terms of this philosophy, we started to produce a desk-type separator, which can be - due to its unique demagnetizing system - much more easily and faster cleaned from the accumulated magnetic impurities. This leads to time savings and production efficiency improvements.

From its function and height points of view, this type of separator is identical with the above mentioned separator so it is possible to replace it with a new model, without a need of any modifications. Also, it is equipped with a combing roof and ferrite magnets.

Magnetic separators with automatic cleaning serve for separation of metal magnetic impurities. As a standard we offer three types: input size 250x250, 400x400 and 500x500 with the capacity up to 150 t/hour. Automatic cleaning principle consists in pouring the material through the central part of the magnetic separator. At given intervals, caught metal impurities are lifted to the left or right hopper. Great advantage is that the material flow does not have to be disconnected in case of cleaning.

On contrary to the type described above, this magnetic separator has several crucial benefits and innovative features:
 
• Its magnets are firmly attached to the separator body so there is no risk of injury caused by magnetic core catching on cleaning, e.g. to a metal floor or another metal structure.
• Due to that, a risk of magnetic core damaging is significantly lower.
• Easy cleaning.
• Better safety at work.
• On cleaning, no material gets onto the magnetic cores.
• No cleaning agents needed.
• Damaged pipes can be replaced easily.

Rotational magnetic separator consists of magnetic telescopic pipes located in the box structure ended by the flanges. Component with magnetic pipes is located on a shaft driven by the electromotor (400 V). Therefore, during the separation magnetic pipes are fluently rotating that is decreasing the risk of grinding through magnet covering pipes by an abrasive material, and also it is decreasing the risk of the separator clogging by a bulk material with not so good characteristics. The device is surface treated by sanding (for an extra cost it is also possible to supply in a polished version).
Magnetic separator is terminated by square flanges. However, we are able to meet your requirements regarding entering/outgoing dimensions and various ending types.
Separator benefits
1. Very high separation efficiency.
2. The device is made of the stainless steel of the class 1.4301.
3. Rotating pipes are driven by an electromotor.
4. There is decreased risk of pipe grinding through using an abrasive material.
5. There is a possibility of the magnetic pipe rotation speed.