Ultrasonic Extinction | Particle Size and Concentration from below 0.1 µm to 3,000 µm
Liquid dispersions with a high concentration of solid particles or droplets, often totally opaque, are typically found in production processes. For optical analysers, sampling of a small partial flow of the main product stream combined with a high degree of dilution is required. Dilution not only causes an extensive preparation effort, but often changes the original state of the dispersion.
For such applications, ultrasonic extinction provides an outstanding performance for particle size analysis of suspension and emulsions. One of the major benefits of ultrasonic extinction is the ability to operate in highly concentrated mediums, which typically come along with wet process stages. A solid content between 5 and 50 % by volume is the typical range of concentration. These are perfect conditions for ultrasonic extinction, which by principle covers concentrations up to 70 % by volume – typical for paste-like particulate systems.
Instead of electromagnetic waves (light), ultrasonic extinction applies low energetic sound waves. These waves are passing through a suspension or emulsion with 31 varying frequencies. For the introduction as well as the detection of sound waves, a piezo-electric RF-generator and detector set-up is used. The recorded loss of sound energy depends on the size and concentration of particles. A corresponding attenuation spectrum is determined and converted into a particle size distribution of 31 classes.
Using sound instead of light waves, ultrasonic extinction is independent of the level of transparency. Hence, totally opaque materials like ore slurries, water in crude oil or coke slurries, can be analysed. Furthermore, paints, sugar pastes, or pharmaceutical suspensions with high solids contents, rank as standard applications for the ultrasonic extinction principle.
In addition, Sympatec's ultrasonic extinction method allows a rugged and robust probe design that resists typical process conditions. The OPUS probe masters temperatures up to 120°C, pressures up to 40 bar, the entire range of pH-value. It is resistant to aggressive media and abrasive materials. For applications in hazardous atmospheres, an ATEX compliant OPUS version is made available by Sympatec.
The process adaptation of OPUS to vessels or to large pipes is simple and typically uses a 100 mm adapter-flange. For smaller pipes or bypass-lines, specific process adapters are available: e.g., flow-through (FT) or bypass (BP). The sensor may be positioned in a standby (SB) rack.
The WINDOX control and evaluation software provides calculation and display of all relevant and characteristic size distribution values. The OPUS system is fully compliant with FDA requirements and 21 CFR Rule 11. Adaptation to process control systems is natively supported by TCP/IP, Profibus, Modbus, digital or analogue PLC signals.
For many years, OPUS is successfully operating in crystallization, grinding or homogenization processes and proves its manifold performances. With various applications, OPUS is repeatedly revealing new insights – not only in production lines but also in pilot plants and lab settings.
Other products from
OPUS is assigned to following product groups:
- Measurement, control, automation (343)
- Safety and environmental technologies (646)