- 2 pressed segments 22,5°
- 4 lobster back segments 2 x 15° and 2 x 7,5°
When the goods are conveyed through a bend, the pipes are worn not only in one segment but in most cases also in the following piping. In difficult situations two castiron pipes can be installed one after the other. The inside diameters and radii of the cast-iron segments correspond to the dimensions of our 3 mm thick piping, so that cast-iron segments can be inserted in exchange later at problematic places that are subject to wear.
A welded-on pipe out of our slip-over flange range can be used instead of the above mentioned slip-over flange. The slip-over flange piping fits perfectly to the cast-iron piping. Due to the side of the slip-over flange that lies flat on the pipe the extremely sensitive area of the connection is reinforced. As no resistance to surge pressure is required, a sealing of the slip-over flange by factory is not necessary in order to have a simpler and quicker installation.
For all connections pull-rings for cast-iron piping can be used, which are equipped by factory with a permanently elastic sealant that is also suitable for foodstuff. Bulk good brake units and lining of the pipes with polyurethane or rubber on request.