Ecutec's JSM Jet Mill is an autogenous grinding system and therefore ideal for contamination free processing. Multiple horizontally installed nozzles direct pressurized air into the center and provide the energy for grinding products. The fine ground product is elevated by the grinding and classifying air up to the vertically installed rotor where the fines are separated.
ECUTEC's special classifying rotors, which can run at very high tip speeds, lead to a very clean, sharp and ultrafine top cut (down to d98 < 2μm). The vertical orientation of the rotor and the high air throughput guarantees a high efficiency of the grinding and classifying system. Due to the high efficiency extremely steep particle size distributions can be achieved with this mill.
ECUTEC's classifying rotors are available in Mild Steel, Hardened Steel, Stainless Steel and several Ceramics depending on the application. With special Ceramics and special design, ultrafine products can also be achieved with highly abrasive products. Mill linings can be provided either with Al2O3 or polyurethane.
Different nozzle arrangements, different temperatures of pressurized air and/or use of steam lead to a wide range of applications the JSM can be used for: Grinding, Classifying, Mixing, De-agglomerating, De-laminating and Coating can all be done with the JSM.
Typical products processed on JSM's:
- Ceramics (i.e. Oxides, Carbides, Nitrides and Silicates)
- Rare Earth (i.e. Neodymium Iron Boron, Cerium Oxide, Samarium Cobalt, etc.)
- Pure and Contamination Free Products (i.e. Silica Gels, Fluorescents, etc.)
- Resins, Waxes, Fats
- Pigments and Dyes
- Mineral Powders (i.e. Talc)
1. Sharp cut point down to d98 < 2μm
2. Processing of very hard/abrasive products
3. Steep particle size distributions
4. Contamination-free processing
5. Low noise level operation
6. Easy product change due to quick cleaning
Leider gibt es für diesen Aussteller kein deutsches Firmenprofil.
Ecutec, which derives from Engineering and Consulting for Ultra-fine TEChnology was founded in 1996 in Germany and moved in 1999 to Barcelona, Spain whilst the production remained in Germany assuring a high manufacturing standard.
The initial point of the company was a strong demand for production of ultra-fine fillers on an industrial scale. With the development of the TFSseries, Ecutec made a breakthrough in classifying technology being able to produce ultra-fine high value mineral products by dry processing being an alternative to the traditional cost and energy intensive wet process.
The strong dedication to develop new products led soon to new types of classifiers and milling equipment, covering a wide range of applications, materials and finenesses.
In 2002 the company lived the beginning of a new era in its history as the first turn-key plant was planned and constructed under Ecutec aegis. This turning point leads Ecutec more and more to be rather a supplier of complete solutions than only a supplier of stand-alone machinery.
The personal commitment and know-how of the staff and the quality awareness of the production site in Germany, assures the customer state-of-the-art technology and individual support for any customer. Ecutec will continue to try hard to stay the Finest in Classifying.